• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Carrier AI problem

C

Clarke123

Flying on Autopilot
I've set up two runways on a carrier. One along the bow cat and one along the landing area. I've set the first, in AFCAD, to closed for landing and the second closed for takeoff. They takeoff perfectly looks great but they keep landing back on the bow runway. Is there some other way to force them to use the correct runways?
 
What I did when I was messing with carrier AI was to just make one runway the length of the flight deck. I was using WWII prop aircraft though.
 
pfflyers - Thanks, I think I might end up going that route. It'll just be a bit messy and a pain assigning individual parking spaces to avoid conflicting parking.

Willy - That would be fine for a WWII carrier but I'm talking about modern jets and angled flightdecks. I'm trying to get the AI to take off from the catapults and land back on the landing area so it'll look more realistic. Thanks anyway.
 
You must log in or register to reply here.
Back
Top