• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Clear instructions to install P3 please

C

CW3SF

Guest
Most of us have XP or XP Pro and would hope that a set of CLEAR and accurate instructions are inclosed with the P3 disk---- But it would be nice if some of you folks would shed some light on the way you installed P3.

Would you:

1. Run disk clean up and defrag first?
2. Add any patches to CFS3 first? Which ones? Where can they be downloaded from?
3.Play CFS3 first (after the patches or not) before adding the P3?
4.Make choices on install different that caused you to reinstall P3 later?

All I am looking for is information that will not cause a " but first" moment
and put us all in the air ASAP "over the lines".

Thanks CW3SF
 
If you have your CFS3 disk in (I have two drives and it is always in), take it out. I loaded it right on top of P2 and ran it without problems.

Beard
 
Thanks BB I'll add that to the FAQ too if you have two drives. BTW how is it going, I am sure guys here want to know about your experience so far.
 
You must log in or register to reply here.
Back
Top