• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

CP-140 KBT Aurora

Aharon said:
Is this new model base or can I use liveries for my existing KBT products?
Click to expand...

It is possible to use existing P3C textures, but this model is CP-140.
Moreover, I think that it is difficult to repaint the color of the antenna arbitrarily.
We may release the P-3C model later in the same version as CP 140.
 
kbt said:
It is possible to use existing P3C textures, but this model is CP-140.
Moreover, I think that it is difficult to repaint the color of the antenna arbitrarily.
We may release the P-3C model later in the same version as CP 140.
Click to expand...

Thanks for reply and nice to meet you, Mr. KBT!! I have flown many of your KBT Electra products for Buffalo Airways virtual airline!! I also have flown your P-3 models too.

Looking forward to your new CP-140 on avsim or flightsim when you finish your last minute adjustments.

One question: on one of Buffalo Airways virtual airline Electra models, it cannot do tight backtracking on single runway without running into snow or grass. Where in aircraft.cfg can I adjust so that it can do proper backtracking at beginning or end of runway, please as Buffalo Airways uses Electras on very small airports' single runways.

Regards,

Aharon
 
Aharon said:
Thanks for reply and nice to meet you, Mr. KBT!! I have flown many of your KBT Electra products for Buffalo Airways virtual airline!! I also have flown your P-3 models too.

Looking forward to your new CP-140 on avsim or flightsim when you finish your last minute adjustments.

One question: on one of Buffalo Airways virtual airline Electra models, it cannot do tight backtracking on single runway without running into snow or grass. Where in aircraft.cfg can I adjust so that it can do proper backtracking at beginning or end of runway, please as Buffalo Airways uses Electras on very small airports' single runways.

Regards,

Aharon
Click to expand...

If you retreat without using pushback, use thrust reverse, but there is no steering effect. It will be impossible on the specification of FS.




[GeneralEngineData]
engine_type = 5
Engine.0 = 0.167, -20.500, 0.833
Engine.1 = 2.500, -10.250, 1.000
Engine.2 = 2.500, 10.250, 1.000
Engine 3 = 0.167, 20.500, 0.833
fuel_flow_scalar = 0.430
min_throttle_limit = -0.289915 // Minimum percent throttle. Generally negative


Increasing the value of 　"min_throttle_limit = - 0.289915" 　to the minus side retreats, but the brakes work strongly. (Use F2 key)


[TurbineEngineData]
fuel_flow_gain=0.011
inlet_area=1.0
rated_N2_rpm=29920.000
static_thrust=3078.000
reverser_available = 1　←　Please experiment to see if it can be used with TurbineEngine.
 
Mr. KBT,

Thanks for your kind answer and I look forward to download your new CP-140 with awesome Canadian liveries when you finish final adjustments on it.

Regards,

Aharon
 
Hello KBT,

-Thank you for these new versions and decorations of the P-3!
However, I would like to find the old vc on the new FSX models!


This vc in the new models FSX?



Is it possible ?
Thank you!

Alain

-
 
alain0568 said:
Hello KBT,

-Thank you for these new versions and decorations of the P-3!
However, I would like to find the old vc on the new FSX models!


This vc in the new models FSX?



Is it possible ?
Thank you!

Alain

-
Click to expand...

I lost the source of that VC model.
Rebuilding the VC you indicated is difficult.
 
Hello Kbt,

-Thank you for your reply!
It's really a shame!
Maybe you could improve the panel vc, creating new possibilities to add some gauges-because now we can not add anything !!!: ((
For example:
-position indicator landing gear
-position of flaps
-control opening of traps of the bomb bay / torpedo
-AOA indicator,
-and 4 switchs on the top left of the panel:yoke,gps ,auto pilot,.....
-Various icons, radios, map, etc ...(-like the first version!)
Thank you for your work.
cordially


Alain
 
alain0568 said:
Hello KBT,

-Thank you for these new versions and decorations of the P-3!
However, I would like to find the old vc on the new FSX models!


This vc in the new models FSX?



Is it possible ?
Thank you!

Alain

-
Click to expand...

What if we merge the old VC with the current models, wouldn't that work?
 
You must log in or register to reply here.
Back
Top