• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Cs 767

J

jeansy

No longer active
Ive had a look at the Captsim pages for some mock 767 AWACs and KC paints, most of the links are dead

does anyone know of any active links for USAF paints for both models

Thanks in advance
 
Ive changed VCs to the 757vc

All the animations work fine and gauges are good

Ive avoided using the pmdg VCs as ive found once a pmdg vc is used outside its model it messes up the overall pmdg install as the cfgs are linked to paints
 
Hi Jeansy

I Don't know of any links but I did back up USAF awacs and Tanker paints.
If you want i can sendt them to you.
 
I wont say no Krair

Im looking for a gap filler until i find time to do some myself

Thanks in advance
 
jeansy said:
Ive changed VCs to the 757vc

All the animations work fine and gauges are good

Ive avoided using the pmdg VCs as ive found once a pmdg vc is used outside its model it messes up the overall pmdg install as the cfgs are linked to paints
Click to expand...

I tried that aswell but i cant see over the panel out of the windows.
My eyepoint is too low or it just sits too high in the model .
Is there a way to adjust that ?
 
Spook48 said:
I tried that aswell but i cant see over the panel out of the windows.
My eyepoint is too low or it just sits too high in the model .
Is there a way to adjust that ?
Click to expand...

This is the view adjustment I made in the 767 aircraft cfg

[Views]
eyepoint=69.55, -1.70, 5.6

the numbers are are forwards/backwards then left/right then up/down

if you make the numbers negative it will go the opposite
 
You must log in or register to reply here.
Back
Top