• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

.dp help needed...

C

Cowboy1968

Charter Member
Help!!!

I am needing the help of someone that can help me zero the guns of a plane I am working on. I just don't have enough understanding i guess in doing it.

So if you can help me, please pm your email address so i can send you the plane and associated files.

Cowboy
 
Help?

Cowboy, here's how to adjust the bullet stream in relation to the reticle...

Open the panel folder the panel.cfg with notepad. Find at the very top of the file [VIEWS]. If you don't have [VIEWS] insert the following lines.
[VIEWS]
VIEW_FORWARD_WINDOWS=%window_title_00%
VIEW_FORWARD_DIR=2.6,0.0,0.0
The 2.6 is the figure you want to play with. Increase it (2.7 or 2.8 ....) will raise your stream of bullets. Lower it and the stream goes down.
If you have allready [VIEWS] insert the two lines on top of the views. Write carefully, because the addition is case sensitive.

To adjust the panel height in relation to the reticle....

Open up your panel cfg. again and look for the Default view, it's usually found at the bottom of the cfg file.

[Default View]
X=0
Y=0
SIZE_X=8191
SIZE_Y=2450 <<< decreases here will lower the panel to fit the CFS2 default reticle and unblock tracers
But beware, with some panels if you lower too much you will encounter a black band across the lower region of the screen.

Thats all I got maybe one of the vet's can offer more clarity.. :ernae:

G
 
You must log in or register to reply here.
Back
Top