• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Flightport_Soloy_Mark2_V1_P3DV4.zip

TiAr

Charter Member
620715213228349406.jpg

A new entry has been added to Add-Ons Library, category Prepar 3D / P4D Add-Ons

Description: P3DV4 native Cessna T 206 H Soloy Mark 2 Turbine Pac.

By Thomas Roehl and Alexander M. Metzger.

It contains 9 different models with 12 repaints.

All models are prepared to use alternative avionics like F1 G500/600, F1 GTN 750/650, F1 GNS, Bendix KLN 90B and RXP GNS. Instructions for the installation of RXP GTN are included.

Important: XMLTools for P3DV4 must be installed to get a realistic engine behavior. Please read readme/manual.

March 2018,

Thomas Roehl

To check it out, rate it or add comments, visit Flightport_Soloy_Mark2_V1_P3DV4.zip
The comments you make there will appear in the posts below.
 
Can't get engine running

Hi,
It's a nice aircraft, but I can't get the engine running. I have red the manual and tried many different settings of the controls. The start enginge is moving, stops, moving again, stops, moving again but no ignition. Have started an engine in other aircraft and switch over to this but no luck. Any help is appreciated!
Jonny
 
Hi,
It's a nice aircraft, but I can't get the engine running. I have red the manual and tried many different settings of the controls. The start enginge is moving, stops, moving again, stops, moving again but no ignition. Have started an engine in other aircraft and switch over to this but no luck. Any help is appreciated!
Jonny

I'm right there with you :banghead:

LouP
 
I have XMLTools installed and have read readme/manual many times. Must be somthing else in my installation but I can't find out. How to find out if XMLTools are i use?

Been a while since I used her but let me see if I can do a cold and dark with her.
 
When the plan loads she loads with the Fuel selector to Both. Switch to either LEFT or RIGHT tank and BAM, starts.
 
Back
Top