Floating buildings in Orbx scenery

Navy Chief

Navy Chief

Senior Member
Had not loaded a flight in any orbx sceneries for a while, and tried one at Falls City this evening, as i had bought the Milviz Huey. I noticed a obvious problem with some buildings "floating" several feet above the ground. Tried finding answers on Orbx forums, but navigating those forums is damn near impossible. Nc
ed
attachment.php
 

Attachments

  • received_1625208540826734.jpg
    received_1625208540826734.jpg
    38.3 KB · Views: 2
Yep, I see that with Orbx as well Pete. I'm guessing (as you probably have) that there's either another addon mesh at work here or it's an area where the elevation needs to be adjusted slightly by Orbx in order to correct it. They do a ton of elevation corrections for their scenery and this may be an area they're unaware of. I have entire housing developments floating from time to time, some as high as 500 ft. I just fly on past and keep truckin', lol
 
falcon409 said:
Yep, I see that with Orbx as well Pete. I'm guessing (as you probably have) that there's either another addon mesh at work here or it's an area where the elevation needs to be adjusted slightly by Orbx in order to correct it. They do a ton of elevation corrections for their scenery and this may be an area they're unaware of. I have entire housing developments floating from time to time, some as high as 500 ft. I just fly on past and keep truckin', lol
Click to expand...

Thanks Ed. I will just pretend i don't see them floating!! NC
 
Take scenery option and push OK again to force reload whole sceneries.
Will be ok.
 
I've had this too, often after switching views to look at AI etc. It usually clears on the next load.
 
Is that not what their Vector program is for - another purchase on top of everything else of course.
 
orbx says in all its manuals to set your mesh to 10m,

its a bit of a downer if you purchase mesh thats better than 10m
 
YoYo said:
Take scenery option and push OK again to force reload whole sceneries.
Will be ok.
Click to expand...
That is one of several options, but it doesn't work across the board. Worth trying of course but it goes with what is repeated here many times. . .what works for one (or several) will not always work for the majority. As others have already mentioned, Orbx suggests their own settings for addon mesh, but if it doesn't fit the desired settings for mesh you just spent money on to purchase, then you may run into the very problem Pete has or that I've seen from time to time. To be honest I have no desire to change mesh settings every time I want to fly into another area that requires a change of settings just to get the optimal effect. Unless you're going to sit a stare at a building that's floating and ponder what can be done about it, just keep on taxiing. . . .or fly right on past it and keep on keepin' on.
 
As many here will attest, if scenery is important to you, especially if you fly low and slow, then ORBX is the way to go. I'm glad I bought all the essentials before I retired as some are quite expensive, but in my opinion there is nothing to compare.
 
http://www.orbxsystems.com/forum/to...-in-fall-city-1wa6-version-12/#comment-842334
And are you updated ?
http://www.orbxsystems.com/forum/topic/125638-updates-from-old-website-support-page/

The fix for floating buildings is to reset the flight, recommend you save it wherever you are, exit the flight, and choose it again.

Floating buildings are the result of autogen loading on to a different mesh than what is displayed. I don't entirely understand it but I presume that a coarse mesh is loaded into the RAM, prior to the later mesh. In this case the autogen has been placed by the sim prior to the final mesh being set.
 
You must log in or register to reply here.
Back
Top