• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

For those of you who are familiar with FSX Instant Mision Maker

S

Sid2008

Charter Member
For those of you who are familiar with FSX Instant Mision Maker

Alright, I am trying to make a simple firebombing misssion.
I need to put is an FSX fire effect on a mountain side and tell Instant Mission maker to put out the blaze after a few accurate chemical applications from aircraft.

Any ideas how i tell IMM to put out the "fire" effect after chemical applications?

Thanks,
Sid
 
Once upon a time I used to be familiar with IMM, but didn't reinstall it last time I redid everything. I'd suggest the Flight1 forums for help; http://www.simforums.com/forums/forums.html

My recollection of IMM would be to set up an area that the plane would have to enter, then have the effect turned off. But that's not really much help, is it?
 
I made one of those missions a while back, just to see if I could. I set it up for a three pass operation.

Important! if you want to put the fire out, place the scenery as a Mission scenery object, not as an FSX scenery file.

User should: Reach an area (area located at a fixed position).

In slew mode, position your plane at the center of the fire.

(Use plane position) click that to set the center of your area on the fire. Set AGL to 0. Using the width and feet boxes, make your area box big enough that it includes the entire fire. Use preview mode to check visually. Make your area box height about 500' to allow the plane to enter it on a low pass over the fire. Check the (wait until accomplished) box, so that it won't precede to the next mission parameter until you have entered that box. Compass and pointer setting are up to you, whether you want them visible or not.

In the mission action pane on the left side, copy and paste your (reach the specified area) action twice, so that you will have a total of three passes to make. The mission will then wait for you to enter that area each time.

after the third (reach the specified area) action, insert an (AI/Scenery - Hide AI or Scenery object), and select the fire effect that you placed for the mission.

Voila! After you make the three required passes, the fire will disappear, you put it out!
You can then either end the mission there with the (goal achieved) action, or have the firebomber fly back to base to end the mission.

Hope this helps!
 
You must log in or register to reply here.
Back
Top