• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Fs9 aircraft in FSX

H

hoppy504

Guest
Sorry if this is a old subject. I have added some fs9 aircraft, and have a slight problem. On my monitor the bottom 3rd of the screen is blank.
Is there any easy way to stretch the view to fill the screen or is this coded in the aircraft model file?
Thanks for any advice.

john.
 
It's something in the panel.cfg ... deleting the 2D window lines referencing something like "render 3D" or setting it equal to zero, I think?

I don't remember what if any FS9 aircraft I have installed, but I'm sure I'd know it if I saw it. Try that though, for the moment. It's ringing a big bell in my head but I'm just not quite sure.
 
Ok, been a little while since I have done this, but go to the panel cfg. file and look near the bottom of the file where it chats about window size. You will need to change this. Look at some FSX aircraft and see what their files use.

T.
 
At the bottom of the panel config after using notepad to open change the X and Y to read
SIZE_X=8191
SIZE_Y=6143

Or
SIZE_X=8192
SIZE_Y=6142
 
I've found that just deleting the SIZE_X= and SIZE_Y= solves the problem although I dont know if they are necessary for anything :redf: but havnt run into anything yet.
 
Thanks for the help, I have adjusted the X.Y settings and the views are now back to normal. I was thinking that these settings only affected the panel view.

regards,
john.
 
You must log in or register to reply here.
Back
Top