• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

FSUIPC for P3D

PRB

PRB

Administrator
Staff member
I have FSUIPC version 4.3.9.4 (registered) installed in my FSX installation. I just installed P3D v2.4 and would like to install FSUIPC, but I don't want it to mess with my FSX install. So I downloaded a new FSUIPC, version 4.9.3.7 (unregistered) which I plan to install into P3D. I just don't want my new unregistered 4.9.3.7 version to "think" I want to override my FSX 4.3.9.4 (registered) FSX install, or I will be really really upset, as all my controls for FSX are configured through the registered version in my FSX install. Does this make any sense? I don't dare install FSUIPC for P3D for fear it will FUBAR FSX. Anything special I need to know?
 
PRB said:
I don't dare install FSUIPC for P3D for fear it will FUBAR FSX. Anything special I need to know?
Click to expand...


All your Fsuipc settings are in the Fsuipc.ini file in the FSX modules folder so just make a copy of that folder as a backup.

Install the full Fsuipc package again but let it install for both FSX and P3D then answer "just check existing registration" when it asks about registration.
Then just copy your Fsuipc.ini over to the P3D modules folder and all the settings will be there in P3D for you.

The latest Fsuipc has a new setting you can put in the ini file under the general section UseProfiles=Files
What this does is strip out all of the profile sections from the Fsuipc ini file and place them in a separate directory called profiles, one file for each profile, this really helps to clean up the Fsuipc.ini file and make it much more managable.
 
You must log in or register to reply here.
Back
Top