• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

FSXBA Hornet - how to input radio freq into UFC

delta_lima

delta_lima

Charter Member 2015
Hi all,

Been enjoying this lovely aircraft for a few years now, but only for short carqual type hops.

But looking to take longer trips involving IFR legs, so I need to figure out how radio freqs get input. I’ve cycled the modes, and the UFC will allow me to type the numbers, but they don’t change the radio freq. I can change them on another plane and then have that correctly shown if I hop back into the Hornet, but that’s a dumb workaround. The good news is once the freq is in, then the VOR and/or ILS data shows fine in the MFD. But it’s the input that’s boggling me.

Anyone have a step by step on how to do this?

Many thx!

D
 
You must log in or register to reply here.
Back
Top