I have downloaded CFS2 Curtiss P-40E Version 4 by K. Malinowski & J. McDaniel from the add-ons in Sims Outhouse. The file is 'km_p40e_v4'. I have copied the Gauges file from P40e fo the CFS2 Gauges file. Not all of the gauges are showing up on the panel but they are showing up on the virtual view. I would appreciate any & all help.
-
There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.
The Staff of SOH
Gauge problem
- Thread starter stick
- Start date
bearcat241
SOH-CM-2023
Ok Stick, but we gotta get the terminology right to avoid confusion here. Try extracting the individual gauge files from the zip to the main CFS2 GAUGES folder. Sounds like you're doing something wrong in the extraction process.
Before doing that, check and see if there's a sub-folder named "Gauges" inside your main CFS2 GAUGES folder, then you're messing up with the extraction process. The files inside that gauges subfolder need to go into the main GAUGES folder and delete the empty subfolder.
Its a common thing you see with ppl new to computers to mix up the words "file" and "folder". This causes some confusion when they read install instructions. The easy way to remember: files always go inside of folders, which are the containers.
Before doing that, check and see if there's a sub-folder named "Gauges" inside your main CFS2 GAUGES folder, then you're messing up with the extraction process. The files inside that gauges subfolder need to go into the main GAUGES folder and delete the empty subfolder.
Its a common thing you see with ppl new to computers to mix up the words "file" and "folder". This causes some confusion when they read install instructions. The easy way to remember: files always go inside of folders, which are the containers.
bearcat241
SOH-CM-2023
You're welcome...hope that helped...:typing: