Help needed please!!

djs1

djs1

Charter Member
A few years ago I downloaded a patch for Milton's D18 which enabled progressive exhaust smoke and flame according to the throttle opening, a very effective piece of eye-candy!!
Following a re-install about a year ago I still have the smoke effect but, despite countless attempts at rectification, I have "lost" the flame. The patch was called "d18smoka" which I am certain a lot of you will be familiar with, I have re-downloaded, re-installed, checked and double checked, followed instructions to the letter and still no flame. Has anyone else experienced this and if so is there a remedy or am I missing something?
Thanks in advance for any help
David
 
XML file

Yes, but you also have to make entry to panel.cfg of XML gauge: Here is the whole burrito:

Install: Very EZ:
(1). put the entire folder coco-gauges in the gauges folder of your Fs,
(2). put the 2 Fx files in the effects folder of your Fs,
(3).then backup the Aircraft.cfg file, next open it (with notepad) and add to the light section:
light.10 = 8, 7.5, -6.5, 0.036, fx_coco_d18FlameL,
light.11 = 9, 7.5, -6.5, 0.036, fx_coco_d18FlameL,
light.12= 6, 7.5, 6.5, 0.036, fx_coco_d18FlameR,
light.13= 7, 7.5, 6.5, 0.036, fx_coco_d18FlameR,
(4).Then open the panel.vc folder, again backup, next open the panel.cfg files
and add to the [window00] section: (Same thing for the panel.novc folder.)
gauge63=Coco-gauges!CocoFXControlTwinjet.xml, 0,0
(5).Please, you need to go into the cockpit 2D once for activate the gauges.
(Normally when you load a plane the first sight is the panel, so .... )

Chuck B
Napamule
 
You must log in or register to reply here.
Back
Top