• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Help with He111 start PLEASE

Marvin Carter

Marvin Carter

Charter Member 2015
Guys I have a problem with the Alphasim He111, when I shut it down no matter what I try or do I can not get it to fire back up. Is this some thing that can be changed in the cfg file or is it in air file, or something? Any help will be greatly appreciated!!!
THANKS!!!!!
 
You're right Marvin! Just tried a cold start as per the checklist (use Ctrl/E) and it doesn't start.
 
Marvin Carter said:
Guys I have a problem with the Alphasim He111, when I shut it down no matter what I try or do I can not get it to fire back up. Is this some thing that can be changed in the cfg file or is it in air file, or something? Any help will be greatly appreciated!!!
THANKS!!!!!
Click to expand...

Sometimes lowering the value for idle_rpm_friction_scalar -- edit: should be the starter per next post -- apologize -- in the Aircraft.cfg will help. I don't have this model so I can't check it for you.

Rick
 
Sometimes raising the value for the normalized_starter_torque entry in the aircraft.cfg will fix it. If it is at 0.30 try changing it to 0.50 and see if that helps.
 
ALphasim has the tickit think going, tryed it two time allready no response from them, thought I would try here. Once the support forum was closed down haven't been getting much help from them. I'm pretty much dun with them any way.
 
Got it, Change this
normalized_starter_torque= 2.50 //Starter torque factor
to this
normalized_starter_torque= 3.50 //Starter torque factor
It takes a min. but will start!!!!!!
Thanks guys!!!!!!!
 
You must log in or register to reply here.
Back
Top