HU for the Breezer Sport

grunau_baby

grunau_baby

SOH-CM-2024
With all the new aircraft being released recently it is hard keeping up.

This little freeware gem deserves a little attention: the Breezer Sport
MSFS_149.jpg

MSFS_147.jpg

MSFS_148.jpg

Still work in progress, but allready a joy to fly. Fast and agile.

Some information about the real thing you´ll find here.

Alex
 
It also flies like on steroids:smile-new: The power it offers is great for mountain flying.
MSFS_150.jpg

MSFS_151.jpg

Though it feels a tiny bit wobbly on approach, a bit unlikely for a sporty plane like this. But since it´s WIP it may get adressed.

Alex
 
It's a very nice little plane, but I have no pilot or co-pilot visible in the external view. Pilot and co-pilot are set to "default"
in the general options. I tried changing to other pilot/co-pilot selections, but no luck. The pilots and co-pilots are showing
in external views for other default and third-party aircraft. I tried re-downloading twice, but again no luck.

Any thoughts? Could it be a pathway problem? I have Steam MSFS, with MSFS, including the Community folder, on D drive.

Otherwise, the plane looks good and seems to fly quite well, although I haven't had it out much yet.

Thanks - RobM

PS: there was an error message when extracting that the "BREEZER_SPORT_SILVER_AIRFRAME_PROP_BLURRED_SIDE.PNG.DDS"
was too long to be copied, but I managed to get around that. I don't think that would have had any effect on pilot visibility.
 
Had the same problem with the invisible pilots. Just open the flight_model.cfg file and set/replace the lines/values under [WEIGHT_AND_BALANCE] as following:

station_load.0 =160, -1.379667, -0.86, 0, pilot, 1
station_load.1 =160, -1.379667, 0.86, 0, copilot, 2
station_load.2 =10, -5.379667, 0, 0, , 3

That at least gives you the default pilot. Weight an ballance settings now work, but passenger stays invisible in external view, even when included in the weight section.
 
grunau_baby said:
Had the same problem with the invisible pilots. Just open the flight_model.cfg file and set/replace the lines/values under [WEIGHT_AND_BALANCE] as following:

station_load.0 =160, -1.379667, -0.86, 0, pilot, 1
station_load.1 =160, -1.379667, 0.86, 0, copilot, 2
station_load.2 =10, -5.379667, 0, 0, , 3

That at least gives you the default pilot. Weight an ballance settings now work, but passenger stays invisible in external view, even when included in the weight section.
Click to expand...

Thanks loads! That worked great.

-RobM
 
Sticky well deserved.

First update is released at flightsim.to The pilot and copilot issues are obviously addressed and solved.:applause:

Looks a lot better this way!
MSFS_152.jpg
 
Last edited:
You must log in or register to reply here.
Back
Top