• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

I BEG YOU,i need help please

Daveroo

Daveroo

Members +
i have an all CH products set up,rudder peddles,eclipse yoke,i had two throttle qauds ( one missing,wont go into that again)and i had it working fine for a short time...now my throttles wont work again,,,,EVERYTHING else works fine,and in single engine it seems to be ok,but in ALL my twins no mater who made the plane ,the left engine will stay half open,and the right engine will operate normal,,,,half the time..the other half its reversed,,,,,ive calibrated,,ive gone back to "reset defaults" ,i changed the settings in controls for the ( now i cant think of the terminology)2 slider bars turn it up or down...sensitivity?....anyway..did no good,,,made it worse accually.....i have FSUIPC i think i have the latest,ill have to check,,,only thing holding me back...unless i just dont "get it"...you have to calibrate each throttle,mixture,prop for EVERY airplane seperatly in the entire sim,,one at the time?or what?..i went to do it once and i had to chose a plane,and i thought,dang if i have to do all 100 or whatever i have...is it worth it???

someone please gimme some advice..

Dave
 
Dave, you mention playing with the sliders in FSX and then mention using FSUIPC.
If your using FSUIPC for your control assignments you MUST delete all axis assignments in FSX or they will conflict.
You can use FSUIPC to assign seperate controls for each plane individually but you can just use a common profile if you want.


Edit: re control conflicts the reverse is also true. If you have FSUIPC installed and use the default FSX controls make sure there are no controls configured in FSUIPC.
 
ive never done any assinging in fsuipc...but ill do it fo nessicary...going to read the posted website first...thanks guys
 
You must log in or register to reply here.
Back
Top