• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

I need help with table 1503/4/6

warchild

warchild

Charter Member
could someone please tell me the mysteries of tables 1503, 1504, 1506?? how do they work?? I need to duplicate the thrust curve vs throttle of a lyulka al-31F and although i can easily get the plane to reach mach 2.3, getting it to fly at 190 knts is a real mess.. I know these tables are where i need to be, but i dont understand the ratio between the two curves in each table. If someone could instruct me on how to properly adjust these curves so that i get the correct response at the correct throttle setting, i would greatly appreciate it..
Thanks
Pam
 
Perhaps of some assistance is a jet thrust flow chart on Jerry Beckwiths mud pond site. These tables can be a bit tiresome as one must adjust the curves one at a time to get each Mach level in correct relation. Bernt recently went through all of this with the F15 so hopefully he had some good points. I am lucky that my projects are currently really slow or solidly sub sonic.

Good luck! T
 
Thanks tom..
Sorry it takes me so long to reply. I dont focus so well any more without my med. I'll head over to the mudpond now and download those.
Pam
 
Pam:

Hope you are getting this sorted out. In effect N2 generated the gas production to run the N2 in a two spool engine. There are low vrs high mach curves for the two curves. To complicate the matters "reheat" is used to achieve plus oe Mach operation. So drag values come in here, and then often depending on the planform, operation at slow speed brings in high AOA drag and perhaps gear and flap drag.

So definitly a bunch of multiple variables.

Good luck! Tom
 
You must log in or register to reply here.
Back
Top