With the current trend of flight simulation manufacturers, producing simulators,
SANS the key commands, I thought that I'd help the next simmer by supplying the key commands for WARTHOG DRIVER:
(All credit goes to
http://web.archive.org/web/20150412...lations.com.au/index.php?title=Warthog_Driver. Very,very,very,very,very,very much appreciated!!!!!)
9.8 - Keyboard Commands
TacPack and Panel commands
SHIFT + CTRL + C - Trigger Keypress.
SHIFT + CTRL + V - Pickle Keypress.
SHIFT + CTRL + M - Turn keyboard mode on/off.
SHIFT + CTRL + N - Turn on NVGs.
Shift+3 = Stores Management Page
Shift+4 = Station Selection Page
Shift + CTRL + W - Re-arm Aircraft
RWR Commands
F - Flare Release Consent
C - Chaff Release Consent
J - Jammer Xmit Toggle / Also mapped to switch, requires Jammer Power and Jammer to be on the Aircraft for it to work.
SHIFT + CTRL + P - Turn Pave Penny ON/OFF
Stores and Station Selection Commands
Ctrl + A or the switch in the cockpit will turn the Master arm from SAFE to ARMED.
If Master Arm is not set to safe and the Gun Safe switch is not set to safe then:
Trigger - will fire the GAU-8 so long as there is ammunition and the weapon has not taken significant damage.
If Master Arm is not set to safe, Equipment power is On and a store is selected.
Pickle - Will attempt to cycle and drop current wing stores.
DELETE - When carrying a Targeting pod commands laser to fire.
SHIFT + DELETE - Turn laser off..
CTRL + J - Jettison currently selected station store.
SHIFT + CTRL + J - Emergency Jettison all Stores
HUD AND SENSOR OF INTEREST (SOI) COMMANDS
CTRL + U - Cage/Uncage the HUD.
SHIFT + C - Step through Bomb modes. (Manual/CCIP)
SHIFT + UP/DOWN - Adjust Gunsight up/down in WD1, Adjust Gun or Rocket Range in WD2/EXP
SHIFT + LEFT - Gun Primary on sight
SHIFT + RIGHT - Rockets Primary on Sight.
UP/DOWN/LEFT/RIGHT - Move Sensor of Interest in direction.
SHIFT+CTRL+UP - HUD to Primary SOI.
SHIFT+CTRL+RIGHT - PavePenny Primary SOI (Note this is the same Laser Tracking features as the targeting pod and will
default to using the targeting pod when available)
SHIFT+CTRL+LEFT - Targeting Pod/Mav Primary SOI.
SHIFT+CTRL+DOWN - Drop All SOI's.
HUD PRIMARY SOI:
CTRL+UP - DESIGNATE, passes current HUD-TGT position to LASER and Centers FLIR on HUD TGT as well as ground lock position.
CTRL+DOWN - UNDESIGNATE, Returns HUD-TGT position to boresight.
FLIR PRIMARY SOI:
CTRL+UP - First hit will allow slew, second hit will ground stabilize, third hit will designate fourth will start lasing.
CTRL+DOWN - Reverse of Up.
CTRL+RIGHT - Zoom FLIR in
CTRL+LEFT - Zoon FLIR Out
Now, hopefully you can enjoy your flight experience!