KBT RP-3 VXS-1 BuNo 154589.zip

jmbiii

jmbiii

SOH-CM-2026
702813967172221774.jpg

A new entry has been added to Add-Ons Library, category FSX Skins

Description: A texture set of the Lockheed NP-3 aircraft operated by VXS-1. This paint represents NP-3D, BuNo 154589, for the Naval Research Laboratory as it was in the 1980's and 1990's.

The textures are in uncompressed .bmp format for FSX. Two fltsim sections are provided, one with the under wing tanks and pods, and one without.

The KBT RP-3 model without the mad boom is required.

To check it out, rate it or add comments, visit KBT RP-3 VXS-1 BuNo 154589.zip
The comments you make there will appear in the posts below.
 
Same here.

I'm not sure if I even have the P-3 required to add this new paint. I have the main P3C Orion/P-3A AeroUnion/P-3B and the RP-3D. I tried to add the paint to a couple of the P-3's I have so far, but it didn't work.

George
 
Your non-mad boom model

George Kuhn said:
Same here.

I'm not sure if I even have the P-3 required to add this new paint. I have the main P3C Orion/P-3A AeroUnion/P-3B and the RP-3D. I tried to add the paint to a couple of the P-3's I have so far, but it didn't work.

George
Click to expand...


In case you haven't already had an answer. The non-mad boom model is listed as NP-3D_VXS-1_FSX.zip on the One Drive site. Took me a bit of noodling around to figure it out. It should go with the NP version and not the RP version
 
Last edited:
You must log in or register to reply here.
Back
Top