LDR FSX G73 Grumman Mallard

ejoiner

ejoiner

Charter Member
After a couple of months in purgatory due to no flight controls, I am starting to catch back up on all the cool releases I missed. One of which is the AWESOME Grumman G-73. I downloaded the aircraft. Did the install, ****, and then checked out the airplane. Gorgeous... payware quality completely. I only have one problem. I cant get the sucker to get over about 50 knots on takeoff run on land or sea. I set trim to 7 deg up as per manual. full power, etc. nuttin. Will run out of runway and never rotate. Ive tried more up trim.. doesnt help. I tried fooling around with the mixture, didnt seem to help.

I went BACK to the manual to see if I missed something and cant find any specific advice on taking her off. Is there a particular method needed? Also the elevator trim doesnt seem very effective to me.
 
ejoiner said:
After a couple of months in purgatory due to no flight controls, I am starting to catch back up on all the cool releases I missed. One of which is the AWESOME Grumman G-73. I downloaded the aircraft. Did the install, ****, and then checked out the airplane. Gorgeous... payware quality completely. I only have one problem. I cant get the sucker to get over about 50 knots on takeoff run on land or sea. I set trim to 7 deg up as per manual. full power, etc. nuttin. Will run out of runway and never rotate. Ive tried more up trim.. doesnt help. I tried fooling around with the mixture, didnt seem to help.

I went BACK to the manual to see if I missed something and cant find any specific advice on taking her off. Is there a particular method needed? Also the elevator trim doesnt seem very effective to me.
Click to expand...
Check your fuel and ballast tanks, you are probably overweight.
 
ejoiner said:
Bingo. Thats what it is. In this LDR version its badly out of whack. I checked and the plane was like 19000 lbs overweight!! In default configuration!
Click to expand...

It's like that to enable it to simulate the weight of the water from a leaky hull. That's why you have the bilge pumps. At least I think that's what I remember from the manual....
 
Eric check your PMs, I replied to your question there but your bilge tanks should auto-empty on aircraft load but sometimes it appears that the gauge initialization requires an aircraft re-load before it kicks in. It will only need to initialize once and then every subsequent load should work fine.
 
You must log in or register to reply here.
Back
Top