• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

LikSki's Champs...

Cazzie said:
Good quick rendition falcon. If you are having problems with the door, zip the fuselage .psd and post the zip here. I'll fix it for you. The door and tails (af the AC, BC, et al) are the most difficult on LilSki's Champs to align all, it takes some finagling. That's a fine looking Champ tomford, do you have any other close up phots of the interior and exterior? I have LilSki's Champ and Tom's CR1 Champ for FSX in FSX. Tom's has better frame rates. I used the Add-On Converter and made 2048 .dsd textures with Martin's DXTBitmat. But as with all FS9 carry overs, I find that frames rates are lower in FSX. I like flying my Christmas Champ this time of year.

View attachment 77426

Caz

Tom's CR1 Champ exclusively for FSX is butt-cheap and can be found here: http://cr1-software.com/addons/aeronca-champ/
Click to expand...

Not sure what you mean by quick rendition. I only used 32bit so that I could view the progress in Fsrepaint. Also I haven't had any problems with interiors or exteriors that I couldn't figure out myself thanks.
 
Cool Falcon, realize that the door stripe has to be smaller in diameter and up a little higher from the stripe on the main fuselage and nose. All must be aligned. Looking forward to the repaint.

Caz
 
rdaniell said:
Do you live in Alabama? I lived in Clanton, Alabama, when I owned the champ. The photo I attached was taken at Clanton. Is the champ you rent N3547E? That would be just too cool. Second question: Is that a Citabria that you're sitting in in your avatar?

RD
Click to expand...

I do live in Alabama, near Huntsville. My EAA Chapter (190) is out of Moontown. The Champ is NC82984. And the photo is in the 2002 Citabria Adventure (7GCAA) owned by Acro Air at Madison County Exec. That's the plane that I did (most) of my primary training in. We have got an amazing variety of rentals available here in North Alabama!
 
You must log in or register to reply here.
Back
Top