• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

MCX export error fix

L

lazarus

Charter Member
Export fail. Main string ARGS error.:banghead: Found one solution for that. Some stuff errors out on that code, very annoying.
I was trying to get the Alpha A90 ekranoplan :banghead:converted, kept getting that error code.
I traced it back to texture names with non letter characters in the the name. In particular, MCX does not like ampersand (&) in the texture titles.
Doesn't seem to bother dynamic VC panel tex's, though.
If you are getting that error on export, rename any textures with & @ # $ % + or what ever.
Won't help with the 68K vertice error, though.
 
Ran into this one recently, too. Removing illegal characters from the aircraft.cfg did the trick.
 
I though I saw some shifty looking characters loitering around the cfg, but I simply assumed it was the thought police again :biggrin-new:
Good to know the cfg can do it too, thanks Bjoren. MCX doesn't actually glitch often, it's nice to finally kill that one off. If I can get that thing around the vertice limit error, It'd be aces.
 
The only way to fix the vertex limit error when modeling in GMax, etc...is to clone the material, alter, say, specular power by 1 and apply the material to some of the problematic parts.

When only working with MCX, this needs to be done by editing some lines in the model's .x file. I think renaming the material of some of the problematic parts (e.g. "Material VC_1_C0" -> "Material VC_1_C01") and then altering the specular power value (third line in the "FS10Material{}" section and a single value).
Finding the parts in the .x file, however is quite a bit of a challenge. Assuming that MCX states the material causing the error, you can simply CTRL+F your way through the several thousand lines of text, but if not, you'll better have a calculator ready (the first number below "MeshTextureCoords" states the number of texture vertices for a given part, I think).
 
You must log in or register to reply here.
Back
Top