-
Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.
Mirage 2000C - open beta 25th Dec. / M2M
- Thread starter YoYo
- Start date
Alpha Two Zero
Members +
Remember when I said i was working on the seat?
Hi Guys,
Found this over at M2M. The Admin Guy has been working on the seat well he's put a shot of the work he's done so far this is just the bottom section can't imagine what the rest looks like. He's also working on the canopy. I have this Aircraft and the detail that these Guys are putting in is out standing. I just can't imagine what the finished product is going to be like. Me thinks the next build is going to great. Cant wait. Regards Timm
Hi Guys,
Found this over at M2M. The Admin Guy has been working on the seat well he's put a shot of the work he's done so far this is just the bottom section can't imagine what the rest looks like. He's also working on the canopy. I have this Aircraft and the detail that these Guys are putting in is out standing. I just can't imagine what the finished product is going to be like. Me thinks the next build is going to great. Cant wait. Regards Timm
:
cortomalteseit
Charter Member
What's the impact of this aircraft on the framerate???
dhazelgrove
Charter Member
skyhawka4m
Charter Member
If you don't have TACPAC what is the standard load out?
hschuit
SOH-CM-2026
Standard clean but you can setup any config by entering the station pounds value in the FSX Payload Settings - see these posts:
http://www.sim-outhouse.com/sohforu...-0-9290-is-out&p=898103&viewfull=1#post898103
http://www.sim-outhouse.com/sohforu...-0-9290-is-out&p=898147&viewfull=1#post898147
YoYo
SOH-CM-2023
spins_vmfa321
Members +
I bought this about a week ago and I've gotta say....
Good F'ing Job, M2M!! This is a joy to fly, and equally enjoyable messing about the cockpit (I like to try to figure stuff out before I read manuals).
Very solid work, and I cannot wait to try it in DCS as well!
Jamal
Good F'ing Job, M2M!! This is a joy to fly, and equally enjoyable messing about the cockpit (I like to try to figure stuff out before I read manuals).
Very solid work, and I cannot wait to try it in DCS as well!
Jamal
M2M First Rate
Not only is it an absolutely stunning piece of work, but M2M has done a great job of managing the public beta. M2M has an active support forum and is extremely responsive. I'm looking forward to completion of their Mirage so they can do the same for the F-15...whoooaa! Kudos to M2M.
Not only is it an absolutely stunning piece of work, but M2M has done a great job of managing the public beta. M2M has an active support forum and is extremely responsive. I'm looking forward to completion of their Mirage so they can do the same for the F-15...whoooaa! Kudos to M2M.
