ORBX SOCAL problem

[trucker17]

Has anyone else had this problem with ORBX SoCal. I have found a few airports that have buildings and trees on the runway.
I have everything set to what is suggested by orbx, and even turned down the settings below what they suggest. but i still get the buildings and trees on the runway.
The only way these dont show up on their, is if i turn the autogen all the way to none.
Anyone have any suggestions. ?

 

[lownslo]

Did you install the latest Orbxlibs (151213) after you installed So Cal?

HTH

Greg

 

[trucker17]

Not yet. I;ll give it a try. Thanks

 

[Penzoil3]

Always install the latest library after installing FTX scenery. Then open FTX Central and apply your desired region, a very necessary step ! I alwary run the Vector Airport Elevation Configurator after a new install too.
Sue