• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

P Clawsons SOC Seagull revised UT

UncleTgt

UncleTgt

SOH-CM-2025
SOC Seagull skinpack1 UT

874916896916479244.jpg

A new entry has been added to Add-Ons Library, category CFS 2 Skins - American

Description: Curtiss SOC Seagull Skinpack 1 by UncleTgt


This is a collection of repaints for my recent revision of Paul Clawson's SOC Seagull for CFS 2.


The textures represent aircraft of the period before Pearl Harbour, & are:


1-O-2 USS Arizona, circa May 1940


5-O-9 USS New York, forming part of the Atlantic Fleet's Neutrality Patrol, circa July 1940


9-CS-17 USS St Louis, Light Grey overall, circa April 1941


5-CS-2 USS Northampton, 7th December 1941


To install, unzip the download to a temporary location & move/ copy files to the matching folder names inside your chosen CFS 2 install.


Thanks to


Paul Clawson for the original aircraft, developed for use in FS2004.


This is freeware and subject to the usual conditions


UncleTgt
JUL 2023

To check it out, rate it or add comments, visit SOC Seagull skinpack1 UT
The comments you make there will appear in the posts below.
 
SOC Seagull skinpack2 UT

238716896918205794.jpg

A new entry has been added to Add-Ons Library, category CFS 2 Skins - American

Description: Curtiss SOC Seagull Skinpack 2 by UncleTgt


This is a collection of repaints for my recent revision of Paul Clawson's SOC Seagull for CFS 2.


The textures represent aircraft of the period between Pearl Harbour & the end of 1942, & are:


Black 7 USS Houston, circa June 1942. Note the large fuselage star.


White 10 USS Portland, circa August 1942


Black 18 USS Augusta, Operation Torch, November 1942


unmarked USS Columbia, circa December 1942


To install, unzip the download to a temporary location & move/ copy files to the matching folder names inside your chosen CFS 2 install.


Thanks to


Paul Clawson for the original aircraft, developed for use in FS2004.


This is freeware and subject to the usual conditions


UncleTgt
JUL 2023

To check it out, rate it or add comments, visit SOC Seagull skinpack2 UT
The comments you make there will appear in the posts below.
 
SOC Seagull skinpack3 UT

245816896919581487.jpg

A new entry has been added to Add-Ons Library, category CFS 2 Skins - American

Description: Curtiss SOC Seagull Skinpack 3 by UncleTgt


This is a collection of repaints for my recent revision of Paul Clawson's SOC Seagull for CFS 2.


The textures represent aircraft of the later war period, 1943 onwards, & are:


Black 13 USS Columbia, circa July 1943. Still in 2 colour camo, but with the red edged star & bar.


White 4 USS New Orleans, circa October 1943. Now in 3 colour camo scheme, but still with the red edged star & bar.


Black 9 USS Louisville, circa February 1944. 3 colour camo & the star & bar have dark blue edging.


White 12 USS Louisville, circa October 1944. By now the main task undertaken was SAR for strike crews, so the fuselage star was enlarged, & the upper wing ID numbers start to reappear.


To install, unzip the download to a temporary location & move/ copy files to the matching folder names inside your chosen CFS 2 install.


Thanks to


Paul Clawson for the original aircraft, developed for use in FS2004.


This is freeware and subject to the usual conditions


UncleTgt
JUL 2023

To check it out, rate it or add comments, visit SOC Seagull skinpack3 UT
The comments you make there will appear in the posts below.
 
184316896914711255.jpg

A new entry has been added to Add-Ons Library, category CFS 2 Aircraft - American

Description: Curtiss SOC Seagull by UncleTgt

This is a revision of Paul Clawson's SOC Seagull CFS 2. Because of the extensive nature of the revisions I've decided to upload as a complete aircraft for ease of installation.

This started out as an exercise in improving my G-Max skills. The model has been revised extensively. It's been demirrored, so camoflage textures & wartime markings would display correctly. I replaced the original crew figures with copies of Wolfi's TBF crewmen.

The 30 cal rear gun is new, as is the (imagined) turtledeck. The default flying condition is with the rear canopy open, pilot's canopy closed, & the turtledeck collapsed with the 30 cal deployed, ready for action...the AI aircraft will appear this way.

I added a few details to the cockpit interior. The prop disk has some depth to it, like Akemi modelled his prop disks.

The front canopy opens/closes using the canopy command.

The rear canopy closes operating the tailhook. The 30 cal stows away & the turtledeck raises, the Observer turns to face forwards & the rear canopy shuts.

The SOC had a full width leading edge slat on the upper wing. This has now been modelled, & is operated automatically by PStrany's Me109 autoslat gauge.

The airfile was thoroughly revised to give believable performance in speed, range & ceiling. It could still be improved though...

The dp file makes use of kelticheart's exhaust effects. THere are early & late war options provided.
The early war DP uses Captain Kurt's early war 100lb bombs, my US mk17 DCs, & KM's Internal Tank
The late war DP uses DBolts 100lb bombs, my US mk41 DCs, & KM's Internal Tank

I replaced the VC & 2D panels, although the pilot's forward view is pretty limited!. The panel & airfile contain the entries for catapult launch. I included Bill Kestell's water spray effects for take-off & landing.

For a sound file, I adapted Obio's R-1340 Noorduyn Norseman soundpack. It could still be improved though...

The texture supplied is:

4-CS-15 USS Indianapolis, circa April 1942

Thanks to
Paul Clawson for his original FS2002/2004 aircraft
Shessi & Allen for answering my noob questions regarding G-Max.
Wolfi for the use of his TBF crewmen.
PStrany for the use of his Me109 autoslat gauge.
A big thank you to Allen for his model tutorial, & DOSmdlc_v2 tools, & especially for helping me with getting keyframe animations in G-Max to export properly!!!

This is freeware and subject to the usual conditions

UncleTgt
JUL 2023

To check it out, rate it or add comments, visit P Clawsons SOC Seagull revised UT
The comments you make there will appear in the posts below.
 
:applause: Thanks Unc, I've always found seaplanes and amphibs very entertaining in CFS2.

It must have been quite an adventure for the aircrew who operated these "flying boats" daily under such hazardous wartime conditions.
 
What a wonderful addition and thank you for sharing.

I was wondering if someone might please advise on one small issue I'm trying to resolve.

I brought the model in to FSX and (using Paul's original AIR file, and an alternate prop texture) and it is wonderful! But...

I noticed that when viewing model from the rear, an ugly black black appears in the forward cockpit.

I opened the model in MCX and it displays the following message:

clawson_seagull_kb_1.png


So, being a person who tries simple fixes first, I created several versions of the VC texture mentioned: $VC1.BMP, VC1. BMP and tried placing them in both the model's texture foler, as well as the main FSX texture folder. Neither achieved success...sigh.

Can someone please explain how to get this to display in the game? Is the VC texture some sort of CFS2-only aspect?

I tried to convert the model in MCX to FSX and successfully removed the offending item, but, alas the model now has terribly slow prop and the ailerons now droop....sigh.

I would love to include this model in my hanger, as I have the ships they would scout for already working in my FSX game, and would love to create some missions using them.

I've included a few shots of the model in my game below.

Thank you in advance for any assistance.

KevinB

clawson_seagull_kb_2.jpg


clawson_seagull_kb_3.jpg


clawson_seagull_kb_4.jpg


clawson_seagull_kb_5.jpg
 
The checker board texture happens in MCX as that model part is textured with the Virtual Cockpit gauge panel texture. VC textures should be read from the PANEL folder.

Wish I could be more help but the model doesn't work in my copy of FSX.
 
Brilliant! That worked! Thank you.

Now I just need edit the texture to better suit.

Meanwhile, I can enjoy some delightful exterior flying.

KevinB

Clawson_Seagull_kb_6.jpg
 
Allen submitted a new resource:

P Clawsons SOC Seagull revised UT - P Clawsons SOC Seagull revised UT

Curtiss SOC Seagull by UncleTgt

This is a revision of Paul Clawson's SOC Seagull CFS 2. Because of the extensive nature of the revisions I've decided to upload as a complete aircraft for ease of installation.

This started out as an exercise in improving my G-Max skills. The model has been revised extensively. It's been de-mirrored, so camouflage textures & wartime markings would display correctly. I replaced the original crew figures with copies of Wolfi's TBF crewmen.

The 30 cal rear gun...
Click to expand...

Read more about this resource...
 
You must log in or register to reply here.
Back
Top