• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Please make it stop!

P

PrivateCustard

Charter Member
"Auckland Airport information whiskey......."

It won't bloody stop. I'm trying to enjoy just a little blast in the Hawk, but this constantly repeating announcement is totally doing my head in!

v9uf.jpg


It didn't do this last time I was here. Why now? Is there any way to totally disable the green bar at the top entirely?
 
If you have not done so already, hit the ` key and tune in the local tower or request flight following, this should do the trick ... Mike :wavey:
 
Cheers for the advice guys :)

But, no amount of comm fiddling would stop it, so I shut down the sim, deleted my saved flight and then started again. It hasn't happened since. I'll just put it down to FSX doing what it does best.....being weird!!
 
If it happened with a saved flight it was probably FSX being wonky.

It has difficulty in resetting variables when using saved flights especially if the original flight was started with another airplane.

I flew the Flight Replica's Ultra Cub from Alaska to Florida. Sometime along the way I found I could not tune to any Radio frequencies. The only way to fix it was to start a fresh flight from the last airport I landed at.
 
Sometimes when you fly an aircraft equipped with two radios where the comm 2 is set to ATIS or some other active frequency and your audio selector is set to both, then you switch to a different aircraft with only one radio you will still hear the traffic on the frequency that was set on the comm 2 of the plane you are no longer using. And since the plane you are now using has only one radio you can't change the frequency or deselect 'both'. Check and see if this is the problem. If so just switch to a plane with two radios, set the audio selector to comm 1 and switch back to the plane you want to use.
 
You must log in or register to reply here.
Back
Top