• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

QC Quirk

W

wsmwsm

Charter Member
Every so often, immediately after starting a standard QC dogfight, I instruct the wingmen to attack a specified aircraft and for some unknown reason, get the "can't comply" response(s). They are in the air and unengaged and there is no explanation for this.

The only way to then fix this problem is to delete the uisel, restart, reset everything and move on.

Doesn't happen a lot but is annoying. There seems to be a connection to using driveable vehichles shortly before switching to a QC dogfight, but that I am not certain of that. Seems to occur when using ETO more than MAW, PTO, etc.

Has anyone else experienced this and is there a fix of sorts?
 
check the loadout of your aircraft. Usually for dogfight choose "mpty" or "nothing" or something similar.
 
That's not it. I can run a QC mission without a problem, end the flight, then return to the same mission without changing any aspect of it. . . but after targeting and requesting an attack, I get the "can't comply" response. And I always run with the loadout clean.
 
There have been a number of threads on this subject over the years....unfortunately I can't remember the thrust of them :173go1:
The loadout thing is one that was raised as a possible solution. Another aspect to this is that in the xdp file, a loadout is sometimes associated with a particular mission type. Try editing the mission types for the loadouts in the xdp of the aircraft you are using in the qc mission and see if this helps?
 
You must log in or register to reply here.
Back
Top