• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Question for Conversion Gurus

No Dice

No Dice

Charter Member
Hello All,
I notice in FS2004 while in 2D panel mode, looking left or right ect you have no wing views, just air. But
After ya'll covert them...they now have wing views in CFS2.

Question is, Can an FS2004 mdl be hex edited or otherwise converted to see wing views while in 2D panel mode in FS2004?

VC is fine...But I still prefer a 2D panel anyday.

Dave
 
No Dice said:
Hello All,
I notice in FS2004 while in 2D panel mode, looking left or right ect you have no wing views, just air. But
After ya'll covert them...they now have wing views in CFS2.

Question is, Can an FS2004 mdl be hex edited or otherwise converted to see wing views while in 2D panel mode in FS2004?

VC is fine...But I still prefer a 2D panel anyday.

Dave
Click to expand...

I think that is a trial and error thing. Have u tried that?
 
I am a bit confused Mission,
Have I tried What ?

That is what I am asking, What can be done. I have no idea. Someone in a thread long ago mentioned Hex edit a certain code in the mdl,
I have never found the thread again.

Dave
 
No Dice said:
I am a bit confused Mission,
Have I tried What ?

That is what I am asking, What can be done. I have no idea. Someone in a thread long ago mentioned Hex edit a certain code in the mdl,
I have never found the thread again.

Dave
Click to expand...
Ok Dave , doesnt matter if it is a fs2k4 mdl or cfs2 mdl , open the mdl file with your exeditor and locate 68 00 02 string using your search tool. after that , replace the 02 by a 03 and ssave changes. Is done. :salute: I hope it would be the thing that u are looking for.
If u have some doubt, please ask me again.
 
misson said:
Ok Dave , doesnt matter if it is a fs2k4 mdl or cfs2 mdl , open the mdl file with your exeditor and locate 68 00 02 string using your search tool. after that , replace the 02 by a 03 and ssave changes. Is done. :salute: I hope it would be the thing that u are looking for.
If u have some doubt, please ask me again.
Click to expand...
forget to say that u ´ll need to adjust the view point in the aircraft file of your plane folder.
Regards
Mario Misson
 
Ok , Thanks Mission
I think that is what I was looking for,
Thank you again.

Dave

Ps, be safe my friend
"Laissez les bon temps rouler"
 
You must log in or register to reply here.
Back
Top