• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Rollrate

Open the aircraft config file (inside of the aircraft folder) and go to the flight tuning section:



[flight_tuning]


aileron_effectiveness = 1.0 //<----- Change this number upward in increments: 1.2, 1.5 , etc to get the desired results
 
Is it as easy to make the aircraft more "knive edge flying" capable ?

Best regards
Thomas






StormILM said:
Open the aircraft config file (inside of the aircraft folder) and go to the flight tuning section:



[flight_tuning]


aileron_effectiveness = 1.0 //<----- Change this number upward in increments: 1.2, 1.5 , etc to get the desired results
Click to expand...
 
Probably not. You can increase the rudder effectiveness, but you'll also need more power, which is not easy to implement. The best aerobatic plane I've found for knife-edge flying is Tim Conrad's Zlin Z-50.
 
Yes, that is what i have experienced. The Zlin and the Iris PC9A. However the Zlin is not that powerful. I have suspected it is someshere in the fuselage parameters. best regards, thomas
 
You must log in or register to reply here.
Back
Top