Rudder peddals

W

Wulf190

Charter Member
How can I stiffen these Siatek pedals up? The physical movement is fine, but the rudder control in FS9 seems extremely sloppy. I'm always moving these pedals back and forth (normal I know) but the nose of the panel seems to swing way too much for the movement! Stock C-172/182.
 
Wulf:

A first place to try is in the controls area where you can set both the null zones and the sensitivities. Also make sure you calbrate them first. Saitek may also have software to adjust the response curve. I do not have these pedals, but the CH ones, so sorry if I cannot provide a specific solution.

Good Luck T.
 
I do have them, and Tom is correct. Set them in the senitivites and null zones. Set the brakes there also. I find a small amount of null, and about 90% sensitivity to be about right for most aircraft.
 
You must log in or register to reply here.
Back
Top