How can I stiffen these Siatek pedals up? The physical movement is fine, but the rudder control in FS9 seems extremely sloppy. I'm always moving these pedals back and forth (normal I know) but the nose of the panel seems to swing way too much for the movement! Stock C-172/182.
-
There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.
The Staff of SOH
Rudder peddals
- Thread starter Wulf190
- Start date
Wulf:
A first place to try is in the controls area where you can set both the null zones and the sensitivities. Also make sure you calbrate them first. Saitek may also have software to adjust the response curve. I do not have these pedals, but the CH ones, so sorry if I cannot provide a specific solution.
Good Luck T.
A first place to try is in the controls area where you can set both the null zones and the sensitivities. Also make sure you calbrate them first. Saitek may also have software to adjust the response curve. I do not have these pedals, but the CH ones, so sorry if I cannot provide a specific solution.
Good Luck T.
