• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Same error in ETO 1.5

E

eddie

SOH-CM-2022
I have had ETO 1.4 running just fine, but every time I have tried to update to 1.5, I keep getting this error message- UnitData Model "h75a3" already used! And it won't start. I have not added anything to ETO, have not deleted the H75, so not sure what's going on. With every installation of the next version of ETO, I have run the program to delete obsolete aircraft, and the BDP zapper. Would like to know what is causing this error and how to fix it, hate to reinstall, but not sure how to get around this stupid error message I keep getting. Beginning to think it best to stop at 1.4,lol
 
If you go into your aircraft folder, find "w40_H75A3" and move it* to a temp folder outside of your
ETO install of CFS3 or delete it, that should fix it. :encouragement:

(*the entire "w40_H75A3" folder)

-oops... seems I took too long to post!
 
Last edited:
You must log in or register to reply here.
Back
Top