Motormouse
SOH-CM-2025
No more power even with supercharger=0 in the aicraft .cfg! Bird no fly!
Er, you need to make that supercharger=1, not 0.
Ttfn
Pete
-
Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.
-
Special Server Maintenance
Just when you think you have everything running some what better...
You get a message from the Hosting company. Short story they need to move us to a new server. I have been working with them to plan a good date for all concerned. Here is what we have come up with as a schedule.
- November 4th 17:00 -5UTC shut off the forums and start backup proceedures. During this time there will be no access to the forums or the Resource Section.
- November 5th Continue with Backups and download same until complete.
- November 6th 7:00 turn over server to hosting company to move system to new server
- November 7th - 8th restore backups and upgrade forum software.
If all goes well we should be back online on November 8th.
To keep you updated we will post updates on AVSIM forums.
Thank you for your support.
Sea Fury
- Thread starter SkippyBing
- Start date
Er, you need to make that supercharger=1, not 0.
Ttfn
Pete
MZee1960
SOH-CM-2023
No more power even with supercharger=0 in the aicraft .cfg! Bird no fly!
............ and try it with Piston engine power scalar and propeller thrust scalar (in aircraft config), increased from 1.0 to 1.4.
wombat666
Administrator
Already tried it! No difference! I yelled at it, cajoled it, throttled it, and still couldn't get it up!
You'll go blind!
Now be careful, I said in [piston_engine] change 'turbocharged=0' to '1'. There is a heading at the bottom 'supercharged=1', but only FSX+Acc will read that, so leave it as '1'.
Now to get the HP near its 2480 value & the boost gauge to indicate about 9.5 psi, increase the max_design_mp=from 46.5 to 62 & max_rpm_friction_scalar=1.0 to 1.2
I've also found it impossible to overshoot as the torque is so great at low speed there is not enough aileron power ( as noted in the Pilots Notes) to keep it airborne, so I have reduced the 'torque on roll' in [flight_tuning] from 7.5 down to 2.0. There is still enough twist to make one work hard.
Good luck
Keith
Now to get the HP near its 2480 value & the boost gauge to indicate about 9.5 psi, increase the max_design_mp=from 46.5 to 62 & max_rpm_friction_scalar=1.0 to 1.2
I've also found it impossible to overshoot as the torque is so great at low speed there is not enough aileron power ( as noted in the Pilots Notes) to keep it airborne, so I have reduced the 'torque on roll' in [flight_tuning] from 7.5 down to 2.0. There is still enough twist to make one work hard.
Good luck
Keith
MrZippy
SOH-CM-2026
I do believe that has already happened a long time ago!
@DevOne:
I took your advice and applied it liberally to the appropriate places and, by golly, she's UP!
Now let's see how many more times I can accomplish that feat!
Now maybe if I can just learn to read
UnknownGuest12
New member
Thanks a lot, Sir. Great plane! Stay Safe...