Small Buildings for Scenery Design?

L

LTCSZ

Charter Member
Does anyone know of a source for small buildings that are usable in Airport Design Editor? (ADE)...I need some smaller outbuildings, utility sheds, small garages, etc...Should be in .bgl format...Thanks!

Steve in Kansas
 
I assume ADE will utilize the ez-scenery objects and there are tons of those available both on Avsim and flightsim.com, with the majority of those being on Avsim.
 
Will that SIRP scenery work with FSX? I tried to find out at that site, but cannot determine if so.

Thanks.

NC
 
WOW! :jawdrop: I never knew that scenery even existed either! I don't run FS9, but I sure hope it works in FSX. Any advice would be welcome...
 
SIRP didn't work in FSX the last time I tried it... Unless it has been redone. It used FS9 techniques and some considerable outside the box thinking, so really doesn't port well.

You can definitely use pretty much any BGL library in ADE, just add it through library object manager, but I really would recommend not using FS9 objects in FSX sceneries. It affects frame rate massively on some peoples' systems, doesn't play at all in DX10 preview mode and transparencies cause major graphical anomalies.
 
ianp said:
sirp didn't work in fsx the last time i tried it... Unless it has been redone. It used fs9 techniques and some considerable outside the box thinking, so really doesn't port well.

You can definitely use pretty much any bgl library in ade, just add it through library object manager, but i really would recommend not using fs9 objects in fsx sceneries. It affects frame rate massively on some peoples' systems, doesn't play at all in dx10 preview mode and transparencies cause major graphical anomalies.
Click to expand...

rats
 
I had used the SIRP scenery in FSX< but it was a major FPS Suck whenever I got close. On top of that there were some "crash" issues around airports that began to show up, most likely when it loads the scenery few miles out.
 
You must log in or register to reply here.
Back
Top