UncleTgt
SOH-CM-2025
I'm stumped! I don't know how you can have some gsl objects showing, but not trees. Somethings borked with that install...
The Wake Wildcats might be easier to fix.
These will only show as gsl objects if you put the files in the SCENEDB/INF sub-folders. Same with Shessis Emily wreck.
My only suggestion is to create an 87 Days install again. Run a few flights, just to make sure everything works & you have trees!
IIRC, Apart from the piers objects pack I released, the only "new" tree is a 25m Quadline of palmtrees - you should have everything else.
Note: this autoinstall has everything installed in SCENEDB subfolders.
You can then add & activate Rhumbas mesh, CFS Tropical LC.
Go fly again to check everything still works. Admire the difference the mesh & landclass makes.
If everything's still OK, you can attempt to add the new scenery, replacing the files from the autoinstall where appropriate.
A couple of other thoughts:
You say you had my SWPTO installed. Do the trees show over Papua?
How big is the gsl file? Maybe you need to remove some "out of theatre" gobs. I don't know of a maximum size, but maybe it influences loading ....
The Wake Wildcats might be easier to fix.
These will only show as gsl objects if you put the files in the SCENEDB/INF sub-folders. Same with Shessis Emily wreck.
My only suggestion is to create an 87 Days install again. Run a few flights, just to make sure everything works & you have trees!
IIRC, Apart from the piers objects pack I released, the only "new" tree is a 25m Quadline of palmtrees - you should have everything else.
Note: this autoinstall has everything installed in SCENEDB subfolders.
You can then add & activate Rhumbas mesh, CFS Tropical LC.
Go fly again to check everything still works. Admire the difference the mesh & landclass makes.
If everything's still OK, you can attempt to add the new scenery, replacing the files from the autoinstall where appropriate.
A couple of other thoughts:
You say you had my SWPTO installed. Do the trees show over Papua?
How big is the gsl file? Maybe you need to remove some "out of theatre" gobs. I don't know of a maximum size, but maybe it influences loading ....