• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Spitfire problem?

sixstrings5859

sixstrings5859

Charter Member
Cannot get the AW Spitfire Ver. 2.1 to work properly. When selected a small 2D cockpit shows up and a gunsite shows in the middle of screen and the aircraft is frozen. Causes problems with other aircraft too. Installed gauge file and modded cockpit config. file to work with Win7.Don't know what else to do... Regards,Scott
 
Ver2.1 is similar to Ver2.0. The difference is the front VC cockpit frames.

I think you should download the aircraft again and reinstall it. I have no problems with it.

Does anyone have the same problem?
 
Thanks for the advise but still have the same problems. Tried using the debug dp file but the same problem happened . Don't have a clue to what i'm doing wrong. Haven't had any problems with any other aircraft installing. Below aircraft limit. Installed gauge file and modded panel config to work with Win 7. Thanks for any help. Regards,Scott
 
Found the problem. I didn't modify all entries in the panel config. file. All is fine now. Sorry,my bad. Regards,Scott
 
You must log in or register to reply here.
Back
Top