• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Spoiler problem

Mr.Mugel

Mr.Mugel

SOH-CM-2024
Hey guys, got a problem with my FSX... My spoilers are allways half extended, with every aircraft that has any. I can make them move a tiny bit by using the X52 slider, but they immediately return to middle position. I had them unbound from my joystick allready, but that didn´t help. The last thing I installed before I noticed the problem was OrbX Bob. I wanted to remove that one, but the uninstaller doesn´t work. I installed the HMS Victorious, too, and some scenery, but nothing else was added. And I had some changes in the graphics setup, but only inside of FSX, not in the .cfg. Just took the fsx.cfg out of its folder to build a new one, will report back...

Anyone else had this problem maybe? Could Bob have something to do with it? I´m glad about any help!
 
Ok, new FSX.cfg cured the problem, just trying to find out now, where my old nicely setup veteran fsx.cg is bugged....

Edit: If anyone knows anything that could refer to the spoilers in the fsx.cfg, it´d help me a lot!
 
What about just carrying over all old values except those related to controls from the old fsx.cfg to the new one? ;)

- Edit: Or basically narrow the culprit down by taking over section by section until things go wrong, then revert that section to the new values and start adding old stuff line by line until you found your problem.
 
You must log in or register to reply here.
Back
Top