Carrier Multi-Aircraft Take Off Tutorial.
This process will place a virtual runway over the flight deck of the aircraft carrier, and allow wingmen or groups of AI aircraft, to populate or take off, from the carrier deck.
To make things easy, I created a new airbase in the airbase.dat file, (located in the CFS2\INFO folder.).
1. Create entry in airbase.dat file.
(You can have more then one just increase xxx numbers and change name)
Here is Data for the Airbases.dat file. Fill in the XXX with the next numbers in sequence and do not delete the little square eof marker.
[runway.xxx]
id=xxxx
name=Fake runway one
heading=40
allegiance=0
units_across=1
base_lat=N6* 8.70'
base_lon=E135* 4.68'
base_alt=+64
takeoff_start_pos=28,0
takeoff_stop_pos=1600,200
landing_start_pos=5000,350
landing_touchdown_pos=5,0
landing_stop_pos=150,0
2. Build mission with yourself taking off from carrier.(Start with two wingmen)
(Make sure starting speed of carrier is zero.)
(Try to make the starting heading of the Carrier either North, South, East ,or West.)
This will make things easier when you decide to advance from here.
3. Fly mission, PAUSE, then Hit Shift-Z, and write down starting info. IE- lat, lon, alt, heading.
4. Exit mission Builder.
5. Edit the new "Fake runway one" airbase entry that you placed in the "airbase.dat" file. (use data from step 3)
6. Restart mission builder and load mission.
7. Change takeoff from "Name of Carrier" to "Fake runway one" airbase.
8. Save and Exit
9. Enjoy
Note: If the carrier speed is greater than 20 knts. your wingmen will start their takeoff roll as soon as you start your engine.
B24Guy
