• Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning old domain name stealing credentials

  • Special Server Maintenance

    Just when you think you have everything running some what better...

    You get a message from the Hosting company. Short story they need to move us to a new server. I have been working with them to plan a good date for all concerned. Here is what we have come up with as a schedule.

    1. November 4th 17:00 -5UTC shut off the forums and start backup proceedures. During this time there will be no access to the forums or the Resource Section.
    2. November 5th Continue with Backups and download same until complete.
    3. November 6th 7:00 turn over server to hosting company to move system to new server
    4. November 7th - 8th restore backups and upgrade forum software.

    If all goes well we should be back online on November 8th.

    To keep you updated we will post updates on AVSIM forums.

    Thank you for your support.

Unstable flyers

J

JAllen

SOH-CM-2023
I am experiencing terrible instability with some acft. The Baron and King Air are nearly unflyable. Airbus and Cessnas are solid. Flying with no weather. Increased dead zones on my Warthog. Went thru calibration too.
Am I the only one?
 
I wouldn't touch the dead zones, and would leave those at 0, but everyone should adjust the sensitivity settings for their joystick, yoke, and rudder pedal controllers. I use a CH Products Fighterstick and CH Products Rudder Pedals, and I have the sensitivity set at -25 for all of the aileron, elevator and rudder axes. To me, this is a perfect setting for those controllers, but some may find different results with different types of controllers.
 
With no input from me, hands off, the acft bounce left wing down to right wing down nose up nose down like a drunken pilot. Added a 10% dead zone to rule out jitters in axes.
Did not help.
 
JAllen said:
With no input from me, hands off, the acft bounce left wing down to right wing down nose up nose down like a drunken pilot. Added a 10% dead zone to rule out jitters in axes.
Did not help.
Click to expand...

Did you try reducing the axes as Bomber suggested? I thought it was a turbulence problem for me, but, reducing the axis sensitivity did seem to help for me. Also, I tried a live weather flight for the first time tonight, and it was much more realistic than the canned weather. I had thought I was using live weather the whole time, till I looked closely at the settings (it said "Live" but it wasn't, button was not on live weather).
 
It is critical to get the axis tuned via the main control settings as well as the sensitivity for each axis. That and the trim which itself needs sensitivity tuning. You can experiment with the curves and dead zones for each axis and trim for Roll, Pitch, and Yaw but I would leave the Throttle linear (no curve). Once the tweaking is done, these models fly very well. I added the pitch trim to my slider on the Warthog Throttle Quadrant which works super well like a trim wheel but you have to set those functions to very low sensitivity or it will take you for a very wild ride.
 
You must log in or register to reply here.
Back
Top