• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Unwanted Lighting FX

stuartcox

stuartcox

Charter Member
How do I get rid of these annoying light chains appearing instead of smoke textures?
It only happens with dusk/dawn settings, and it doesn't matter what smoke effect I use.
The smoke settings are in the light section of the cfg, but the same appears with a separate [smokesystem] entry.

View attachment 28157
 
There's a little more info on this over at cbfsim; IIRC Dave Garwoods' Hawker Hunter suffered same, and it was tracked down to a combination of a microsoft 'bug' interacting with particular graphics cards and drivers.

Its generated by the program by the same mechanism that generates 'condensation trails' at altitude; and as you've noticed only happens at dawn /dusk .... annoying; very!!

ttfn

Pete
 
I once saved a quote from a member, but forgot to save their name :isadizzy:

never did try it though, might help?

It may have something to do with one (or both) of the exhaust and heat effects that you are using. There is a parameter inside the effect file (open with Notepad) which is called Faces (I think, I am not near my FS computer right now). If it reads 1,1,1 then try and change that into 0,0,1 and see if that helps.
Click to expand...

Jamie
 
JDTinballs said:
I once saved a quote from a member, but forgot to save their name :isadizzy:

never did try it though, might help?



Jamie
Click to expand...

That sounded like a quick and easy solution...
But unfortunately I do not have a file called 'faces 'in my effects folder!
Where did that come from? I would like to know.

Edit: OK, you meant the actual FX file, not the FX folder! I will give it a try...

SC
 
The SDK has this to say about the Face statement:

Face=1, 1, 1 The direction that the particles face. Pitch, bank, and heading are the constraints for the particles’ facing movement. These are on/off switches because the particles either move in the corresponding direction, or they do not.
To have the particles face you, use 1,1,1. If one of the values is 0, then the particles will be constrained in the corresponding axis. To have the particles remain perpendicular to the ground but still turn and face you, use 0,0,1.

It is obviously related to engines ... and it seems to have a reflective or specular quality. Also initially seems to be similar to the sun or camera lens glare. What was the temperature? Altitude? Was Smoke on - "I" key? What engine smoke effect is used? What is its lifetime say in teh effect?
 
Thanks Milton, I will keep your advice in mind.
Even though I don't understand half of it, I will give it a go!
Nothing to lose..

Thanks, SC
 
You must log in or register to reply here.
Back
Top