• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Warbirdsim p-51b/c - flickering altimeter adjustment knob

V

vonernsk

SOH-CM-2022
Jan's great re-paints for this lovely model inspired me to convert most of them to work in FS2004. When flying these great new skins, I was reminded of the small niggle that I have with the cockpit altimeter. There is an adjustment knob at the lower left side of the gauge and while it operates perfectly well, it has a distracting flicker all of the time.

I have swapped the altimeter out for other examples of the same alt by other designers, but the knob and its flicker remains. Is the adjustment knob a separate gauge ?

Anyone else have this small but very irritating flicker? Or just me?

Will also take the time to thank Jan for these superb productions from the Warbirdsim paint set. Thanks Jan, great work which crosses over to FS2004 well. Lovely 'used' effects including dirt on tyres in one skin!

Mal
 
Hi Mal,
I haven't got this model, but suspect (from your description) it's a problem poly, or overlapping poly, which means it's part of the mdl and not the gauge etc. If it is, there's not a lot you can do about it....:(

Cheers

Shessi
 
It could be overlapping polys as described by Shessi. Buy you could also check whether adding mipmaps to the texture of this knob will solve the problem. As it sometimes does.

Cheers,
Huub
 
You must log in or register to reply here.
Back
Top