• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Wish things would just "work" correctly

LouP

LouP

Flight Sim Junkie
I downloaded the Milviz MD530 for p3d v4 last night and was looking forward to taking it for a flight but the cyclic keeps returning to the full aft position on it's own. It works fine when I shut the aircraft down but as soon as I start it up and get it running, it moves full aft again. I am thinking it has something to do with the force trim they were using but I see no adjustments for that in the configurator and there are no switches in the cockpit to turn it off. Anybody else run into this and if you fixed it, could you share how you corrected it?

Thanks,
LouP
 
Do you by chance have elevator trim tied to an axis? I fought this issue on the md530 many years ago then I realized that my trim axis wasn’t centered. Also did MV finally make the 530 v4 compatible?
 
Yes, it is now compatible. Download the latest installer from the support forum.
Lou, I don't have that problem either. I agree, check all you control assignments.
Sue
 
Hi Guys,

I have a profile for helis in fsuipc that I use. I will check the settings to see if the trim is set up anywhere. I'm wondering if the force trim is still set-up somehow.

LouP
 
Don't see any elevator trim in fsuipc.ini or the p3d.config. Any where else I could be looking?

LouP
 
Got it resolved. There were some buttons assigned to elevator trim on my heli controls. May have been left over from the prior version but all is good now. :)

LouP
 
You must log in or register to reply here.
Back
Top