• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

C-47 V3 - Disable ILS Audio

C

cfelix

Members +
Hi,

I am loving this plane! Thanks for all the hard work. One small problem I'm having is that I can't seem to disable the Morse Code audio when on approach with NAV1 tuned to the ILS. I've tried middle-clicking on the NAV1 label in the Monitor panel and made sure that all switches are set to mute on the intercom panel. The only way I could get it to stop was to change frequency. I'm probably just missing something very simple but I'd appreciate any advice. Thanks.

Charlie - KSBP
 
cfelix said:
Hi,

I am loving this plane! Thanks for all the hard work. One small problem I'm having is that I can't seem to disable the Morse Code audio when on approach with NAV1 tuned to the ILS. I've tried middle-clicking on the NAV1 label in the Monitor panel and made sure that all switches are set to mute on the intercom panel. The only way I could get it to stop was to change frequency. I'm probably just missing something very simple but I'd appreciate any advice. Thanks.

Charlie - KSBP
Click to expand...

Yes, the intercom panel is still a work in progress.
 
morse code

Had the same experience, went through all aircraft and found DME turn on in a third party download, turned it off and situation corrected. Tried to turn DME of in default aircraft no response had to find the main source, hope this helps
 
Have had the same issue with the Morse code bipping and found that turing the DME off in fx the default Cessna 172 cures it, hastle though to have to change planes to cure the annoying bipping.

Berlopez
 
Berlopez said:
Have had the same issue with the Morse code bipping and found that turing the DME off in fx the default Cessna 172 cures it, hastle though to have to change planes to cure the annoying bipping.

Berlopez
Click to expand...

I had the same Morse code beeping :(
Thanks to Monitor panel, I discoverd that Nav2 Ident was on (but Voice on the gauge). Could switch it off with Monitor panel.

Somewhere, I wrongly mentionned beacon switch not working - I confused with the "Anti Collision" switch (some cockpit use this name instead of "Beacon").
My bad - :culpability:

Gérard
 
In Monitor > Avionics, if the NAV1 is highlighted you hear the Marker Morse code. Middle-click to toggle ON/OFF (cp. tooltip).

Somewhere, I wrongly mentionned beacon switch not working - I confused with the "Anti Collision" switch (some cockpit use this name instead of "Beacon").
My bad - :culpability: Gérard
Click to expand...

The beacon switch is only functional if the exterior model has a beacon (or two), in other words, if the model= line references either C47_2 or GAF. The default model is from a pre-beacon era; it hasn't got one.
 
You must log in or register to reply here.
Back
Top