• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Landing gear animation speed

A

aardvark62

Charter Member
Hi All. I'm sure there was something in a thread somewhere on this, darned if I can find it - but can anyone tell me, is there a config entry anywhere that controls the landing gear animation speed ?

Cheers, A.
 
aardvark62 said:
Hi All. I'm sure there was something in a thread somewhere on this, darned if I can find it - but can anyone tell me, is there a config entry anywhere that controls the landing gear animation speed ?

Cheers, A.
Click to expand...

In the aircraft.cfg, Contact Points section, parameters 12 & 13, change the extension and retraction times expressed in seconds.

12 (1.0) Extension Time The amount of time it takes the landing gear to fully extend under normal conditions (seconds). A value of zero indicates a fixed gear.
13 (4.0) Retraction Time The amount of time it takes the landing gear to fully retract under normal conditions (seconds). A value of zero indicates a fixed gear.

point.0=1.000, 13.183, 0.000, -5.683, 1574.803, 0.000, 0.667, 25.000, 0.20, 4.700, 1.500, 5.000, 4.000, 0.000, 0.000, 0.000
point.1=1.000, -0.630, -6.458, -5.643, 1574.803, 1.000, 0.917, 0.000, 0.500, 2.000, 0.800, 10.000, 5.655, 2.000, 0.000, 0.000
point.2=1.000, -0.630, 6.458, -5.643, 1574.803, 2.000, 0.917, 0.000, 0.500, 2.000, 0.800, 6.000, 5.655, 3.000, 0.000, 0.000
 
Ah Yes! Hidden in the Contact points. That's what I was after.

Thanks Milton.

A.

PS. Any news on your current project ?
 
You must log in or register to reply here.
Back
Top