• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Bill and Bill, Lyons and Lionheart

F

Fleet Canuck

SOH-CM-2016
I've just installed wheelcam(Flight 1 View), having learned about it on this forum, and I'm enjoying touring the interiors of my aircraft, and in some cases, strolling around the exteriors.

Actually, the only planes where I'm able to go outside and do a circle check are those created by the two Bills. Bill Lyons, and Lionheart Creations Bill Ortis. All other aircraft have portions of the exterior visible when you go out from the VC mode, but not the entire exterior.

So...I'm wondering why that is. I know Active Camera from my fs2002 days let you walk around all aircraft, but on Flight 1 View zooming in while in spot mode isn't quite the same.

Anyway, I was just curious as to why the entire exterior is visible from VC mode on the Lyons/Lionheart aircraft by the two Bills.
 
You must log in or register to reply here.
Back
Top