-
There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.
The Staff of SOH
-
Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.
dc6 panel
- Thread starter greycap
- Start date
daypharris
SOH-CM-2022
[fltsim]
alias=fsfsconv\dc6pnlKMCC
I hope this was easily explained.., good luck with the increadible CalClassic Dc-6 models! I have them all.
Cheers
Dag
Hello greycap. Where did you place the "dc6pnlKMCC"-folder? It must be placed inside the fsfsconv-folder! This folder you'll find inside Fs9 AIRCRAFT-folder. The DC-6s panel-folder should contain the file; "panel.cfg", and inside this cfg-file you need this text:
[fltsim]
alias=fsfsconv\dc6pnlKMCC
I hope this was easily explained.., good luck with the increadible CalClassic Dc-6 models! I have them all.
Cheers
Dag
hi there couldn't find fsfsconv-folder .so I 'nicked' the panel from the dc4 seems ok at least I can fly the dc6 and see some dials. thanks for your time
greycap
lemonadedrinker
Charter Member
Andy.
hi there found it ! put the file in it ,didn't work and now its gone altogether .
thanks anyway
greycap