• Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning old domain name stealing credentials

  • Special Server Maintenance

    Just when you think you have everything running some what better...

    You get a message from the Hosting company. Short story they need to move us to a new server. I have been working with them to plan a good date for all concerned. Here is what we have come up with as a schedule.

    1. November 4th 17:00 -5UTC shut off the forums and start backup proceedures. During this time there will be no access to the forums or the Resource Section.
    2. November 5th Continue with Backups and download same until complete.
    3. November 6th 7:00 turn over server to hosting company to move system to new server
    4. November 7th - 8th restore backups and upgrade forum software.

    If all goes well we should be back online on November 8th.

    To keep you updated we will post updates on AVSIM forums.

    Thank you for your support.

FSX.cfg setting

falcon409

falcon409

SOH-CM-2026
I was looking through my config settings and came across the shader_cache_primed setting under the [GRAPHICS] heading. My question is. . .should I have one or two entries for this. I currently have two as noted below:

SHADER_CACHE_PRIMED=1693500672

SHADER_CACHE_PRIMED_10=1693500672
 
falcon409 said:
I was looking through my config settings and came across the shader_cache_primed setting under the [GRAPHICS] heading. My question is. . .should I have one or two entries for this. I currently have two as noted below:

SHADER_CACHE_PRIMED=1693500672

SHADER_CACHE_PRIMED_10=1693500672
Click to expand...

Could the 2nd one be for DX10? I don't have that option so I only have one entry.
 
Fsx cfg

I have Acceleration and have only one entry. Also do not use DX10. Check over at FSDevelopers and see if they have an answer. The gurus in my opinion. :dizzy:
 
the second one is for DX10 preview..there are also likely to be two shader cache folders in your root FSX folder..you might have checked DX10 mode in the GUI at one point and later unchecked it.
 
heywooood said:
the second one is for DX10 preview..there are also likely to be two shader cache folders in your root FSX folder..you might have checked DX10 mode in the GUI at one point and later unchecked it.
Click to expand...
Thanks, no need for both then. Don't use DX10 Preview so I'll dump that!
 
You must log in or register to reply here.
Back
Top