• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

FSX.cfg setting

falcon409

falcon409

Moderator
Staff member
I was looking through my config settings and came across the shader_cache_primed setting under the [GRAPHICS] heading. My question is. . .should I have one or two entries for this. I currently have two as noted below:

SHADER_CACHE_PRIMED=1693500672

SHADER_CACHE_PRIMED_10=1693500672
 
falcon409 said:
I was looking through my config settings and came across the shader_cache_primed setting under the [GRAPHICS] heading. My question is. . .should I have one or two entries for this. I currently have two as noted below:

SHADER_CACHE_PRIMED=1693500672

SHADER_CACHE_PRIMED_10=1693500672
Click to expand...

Could the 2nd one be for DX10? I don't have that option so I only have one entry.
 
Fsx cfg

I have Acceleration and have only one entry. Also do not use DX10. Check over at FSDevelopers and see if they have an answer. The gurus in my opinion. :dizzy:
 
the second one is for DX10 preview..there are also likely to be two shader cache folders in your root FSX folder..you might have checked DX10 mode in the GUI at one point and later unchecked it.
 
heywooood said:
the second one is for DX10 preview..there are also likely to be two shader cache folders in your root FSX folder..you might have checked DX10 mode in the GUI at one point and later unchecked it.
Click to expand...
Thanks, no need for both then. Don't use DX10 Preview so I'll dump that!
 
You must log in or register to reply here.
Back
Top