FSX.cfg setting

[falcon409]

I was looking through my config settings and came across the shader_cache_primed setting under the [GRAPHICS] heading. My question is. . .should I have one or two entries for this. I currently have two as noted below:

SHADER_CACHE_PRIMED=1693500672

SHADER_CACHE_PRIMED_10=1693500672

 

[MrZippy]

I was looking through my config settings and came across the shader_cache_primed setting under the [GRAPHICS] heading. My question is. . .should I have one or two entries for this. I currently have two as noted below:

SHADER_CACHE_PRIMED=1693500672

SHADER_CACHE_PRIMED_10=1693500672

Could the 2nd one be for DX10? I don't have that option so I only have one entry.

 

[falcon409]

Could the 2nd one be for DX10? I don't have that option so I only have one entry.

Very possible, hadn't considered that, but I don't use that option (not checked in the menu).

 

[fsafranek]

I have the same two entries under [GRAPHICS].
Different value though: 1693751040

 

[MrZippy]

Another thought that it has to do with having Acceleration??

 

[tgycgijoes]

Fsx cfg

I have Acceleration and have only one entry. Also do not use DX10. Check over at FSDevelopers and see if they have an answer. The gurus in my opinion.

 

[heywooood]

the second one is for DX10 preview..there are also likely to be two shader cache folders in your root FSX folder..you might have checked DX10 mode in the GUI at one point and later unchecked it.

 

[falcon409]

the second one is for DX10 preview..there are also likely to be two shader cache folders in your root FSX folder..you might have checked DX10 mode in the GUI at one point and later unchecked it.

Thanks, no need for both then. Don't use DX10 Preview so I'll dump that!