• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Lockheed S-3 Viking - The Sequel Thread

A beautiful beta release. Really like the engine sounds in front of and behind the aircraft.

A few shots while launching and trapping on the Enterprise.

CVN65_S-3A-80s-2.jpg CVN65_S-3A-80s-1.jpg CVN65_S-3A-80s-3.jpg
CVN65_S-3A-90s-2.jpg CVN65_S-3A-90s-1.jpg CVN65_S-3A-90-3.jpg
 
Had a quick hop - speechless, Dino. Super sweet model, great textures. Am not super familiar with this bird, so will be a great learning experience. Thanks for releasing it as BETA - it's already gorgeous.


Can't find the download link at all.

Dave

Down at bottom of page ....

"If you have read everything, and promise to comply with the rules, you are welcome to download the aicraft by clicking HERE."

dl
 
Absolutely beautiful as usual Dino many thanks. But as usual for me had it less than 30 minutes and I Free Willied it AKA broke it. I didn't even know the rudder folded down Ctrl-W. Now where did I put that manual.

 
Thanks for the appreciation.
I have just realized that the version uploaded is not the latest and greatest... but it is good for testing anyway...
Please take your time - I will not be able to do much work on it for a week or two. Target for final release is in early July.
 
This is a quick & dirty few fixes to help out Dino until the next update.
After a little testing, I found one significant bug that was fixable in the config file. When the S-3 was sitting on the ground, I noticed that with the external tanks full, the model listed to one side. On takeoff it displayed a definite fuel load imbalance. Checking the config, I saw where the lateral position of the tanks was the same. I simply removed one of the minus symbols and the issue is fixed.

(back up your original cfg before making any changes)
Here's the fix:
External1 = -36.0, -10, -4.0, 300, 0.0
External2 = -36.0, 10, -4.0, 300, 0.0 //<--the red showing the changed value.

The other thing I noticed is that the gear retraction/extension sequence seemed a good bit slow. After watching real retraction/extension sequences. I determined speeding the sequence up by half would do the trick. The adjusted valuesare in red:

point.0=1, -20.00, 0.00, -5.45, 1600, 0, 0.95, 70, 0.862, 1.96, 0.5100, 7.4, 7, 0, 260.0, 260.0
point.1=1, -38.00, -5.75, -4.5, 1700, 1, 1.06, 0.0, 0.606, 1.4, 0.5456, 7.2, 7.8, 2, 260.0, 260.0
point.2=1, -38.00, 5.75, -4.5, 1700, 2, 1.06, 0.0, 0.606, 1.4, 0.5456, 7.5, 7, 3, 260.0, 260.0


Also made minor changes in the Autopilot to get a slightly more responsive turn rate. You can just copy & paste the entire section:

[autopilot]
autopilot_available= 1
flight_director_available= 1
default_vertical_speed= 1500.0
autothrottle_available= 0
autothrottle_arming_required= 0
autothrottle_max_rpm = 90
autothrottle_takeoff_ga= 0
pitch_takeoff_ga = 8;
max_pitch=10.0
max_pitch_acceleration=1.0
max_pitch_velocity_lo_alt=2.0
max_pitch_velocity_hi_alt=1.5
max_pitch_velocity_lo_alt_breakpoint=20000.0
max_pitch_velocity_hi_alt_breakpoint=28000.0
max_bank=30.0
max_bank_acceleration=3.8//1.8
max_bank_velocity=6.00
max_throttle_rate=0.10
nav_proportional_control=11.00
nav_integrator_control=0.20
nav_derivative_control=0.00
nav_integrator_boundary=2.50
nav_derivative_boundary=0.00
gs_proportional_control=9.52
gs_integrator_control=0.26
gs_derivative_control=0.00
gs_integrator_boundary=0.70
gs_derivative_boundary=0.00
yaw_damper_gain = 1.0
yaw_slip_control_gain=0.000000
yaw_control_uses_trim=0.000000

:ernaehrung004:
 
You are welcome...

One thing on the gear retraction time - it is set to 14 seconds because the flght manual says so...
 
Another version of VS-41 in Lo Lo-Vis texture.

Great job on the Viking Dino.





Russ
 

Attachments

  • VS-41D.jpg
    VS-41D.jpg
    33 KB · Views: 4
Thanks for the appreciation!

Apparently the Beta seems to work fine apart from some minor defects - no strange surprises or behaviors... I'll wait some days before making any further change but as of today the fixes are really quick to implement... maybe we'll have version 1.00 released before the end of the month.
 
This is the setting I use for vLSO.

[Aircraft.1]
ATC_model=S3
Type=Viking
Name=S-3B
Slow=8.2
Fast=6.2
AbeamClose=0.9
AbeamWide=1.1

The abeam settings are from the S-3B NATOPS.
The slow fast is from the T-45C. I am not sure what the actual settings are.

Russ
 
Well, the onboard AoA indexer is slaved to the Angle of Attack in degrees as follows:
- Green Chevron light 15.5 degrees or more
- Amber "Donut" 14.0 to 16.0
- Red Chevron light 14.5 degrees or less

So donut only is 14.5 to 15.5 degrees - that would be the same as the real thing if AoA units and AoA degrees were the same (but they are not...)...
BTW I would be open to change the default values if other values make more sense...

S3BAoA.jpg
 
Hallo Dino,

congrats to your newest masterpiece!!!:applause::applause::applause:
Such a nice surprise for me this morning. It is already a real superb recreation.
I know, that you are no friend of making a paintkit for your models, but have you considerd to make a white clean paint for your S-3??
I think that there are many repainters, who would like to make more real-world and some fictional repaints for this beauty!
Looking forward to every gift that you present to the sim comunity!

Christoph
 
Anticipated beta release, looks beyond good right off the shelf. Hope a VS-30 paint is in the works (AA 702 would be exact).
 
Dino, regarding the gear retraction/extension time, I saw that value in one of the S-3 manuals as well but from my memory of seeing S-3's at different airfields, the gear movement seemed much quicker. Finding good reference video showing the gear sequence doesn't seem easy to come by but in this early promotional video, you'll see a runway takeoff at !:48 followed by first movement of the left main gear actuator arm at 2:08 and the total sequence appears to be around 8-9 seconds(on actual gear movement). Another video I saw showed about 7 seconds.

https://www.youtube.com/watch?v=03Qi7ac7huU
 
Out of TJBQ bound to MUGM the VS-41 Shamrock goes:redfire: Excellent work Dino.
 

Attachments

  • VS-41.jpg
    VS-41.jpg
    38.8 KB · Views: 3
Back
Top